1. Insert key in ignition and leave in the OFF position

2. Locate theData Link Port. It is locatedunder dash drivers side. Be sure you know
which pins are 8 and 4.

   (Note port is wider at top) YourOBDII port will not
have numbers, use this diagramfor reference.

3.Make sure there are metal contact pins in terminals 8 and 4. Connect 8 to 4 with a
suitablejumper wire (leave the jumperwireconnected throughout the programming
procedure).Makesure you know which terminals are 8 and 4.The vehicle will respond
bylocking and unlocking thedoors to signify entering of programming mode.

4. Close doors.

5. Turn ignition to the ON position (asfar as you can go without cranking the engine).
Doors will lock.

6.Press and hold both the LOCK and UNLOCK buttons together on the first transmitter to
beprogrammed. After about 15 seconds,thevehiclewill respond by locking and
unlocking the doors.Release the buttons on the transmitter.

7.Within one minute, repeat the previous step on the remaining transmitters to be
programmed.

8.  Remove jumper wire applied to th OBDII Port.