1.Start with key out of the ignition, driver door is open (all others closed),and driver
dooris unlocked.

2. Insert key into the ignition (don’t turn it) and pull it out

3. Perform these steps within 40 seconds:

 a. Using the power lock switch on the driver’s door, perform 5 lock/unlock cycles
startingwith lock.Use aneven pace and try to goaboutone cycle per second.
(1 cycle = 1 lock and 1 unlock)

 b. Close, then open driver’s door.

 4. Perform these steps within 40 seconds:

 a. Using the power lock switch on the driver’s door, perform 5 lock/unlock cycles
startingwith lock.Use an even pace and try to goabout one cycle per second.
(1 cycle = 1 lock and 1unlock)

 b. Insert the key in the ignition cylinder.

 c. Turn the ignition to ON (as far as you can without cranking the engine)
then back to OFF

 d. Remove the key from the ignition.

 5. Within 3 seconds, the power door locks should cycle automatically indicating
successful entry into programming mode.
Return to step 1 if the locks do not cycle at this point.

 6. Perform these steps within 40 seconds:

 a. Press the lock and unlock buttons on the transmitter simultaneously for 1
second.

 b. Immediately after letting go of the lock and unlock buttons, hit the lock button
by itself andholdfor 2 seconds. Within 3 seconds, the door locks should cycle
once indicating successfulprogramming.If the door locks don’t cycle, or cycle
twice, repeat steps a and b-your remote has notbeen accepted.

 c. Repeat steps a and b in step 6 for each new transmitter.

 7. Close door.

 8. Grab Key and Remote, step out of car and test remote(s).