The following procedure details the steps to follow for the programming of
additional remote transmitters. Use the first procedure if you have a functioning
transmitter or the second procedure if you have no functioning transmitters.

With at least one functional transmitter

1. Ensure door is open

2. Remove key from ignition

3. Lock the doors using the transmitter

4. Unlock the doors using the transmitter

5. Within 20 seconds of unlocking, insert key into the ignition cylinder and
turn key from the "ACC position to the "ON" position 20 times - leaving the
key in the "OFF" position after the 20th turn.

6. The vehicle's indicators will flash 20 times to indicate successful entry.

7. On the 20th flash of the indicators, press the button once on each transmitter.

8. Once finished, turn the ignition key to the "ON" position to lock in and exit from
the programming mode.

With no functional transmitter - Units programmed for Remote Central Locking

1. Ensure vehicle audio PIN number is known or audio PIN security system is
deactivated prior to battery disconnection.

2. Ensure door is open.

3. Disconnect the negative battery cable, wait minimum of 5 minutes, then reconnect.

4. Within 20 seconds of reconnecting the battery cable, insert the key in the ignition, then
ycle the ignition key from the "ACC" position to the "ON" position 20 times - leaving the
key in the "OFF" position after the 20th turn.

5. The vehicle's indicators will flash 20 times to indicate successful entry. Should the
indicators fail to flash, wait 5 seconds then quickly turn the ignition switch from the
"ACC" position to the "ON" position 10 times - leaving the key in the "OFF" position
after the 10th turn. Wait 15 seconds, then recycle the ignition switch 20 times.

6. The vehicle's indicators will flash 20 times to indicate successful entry.

7. On the 20th flash of the indicators, press the button once on each transmitter.

8. Turn the ignition key to the "ON" position to lock in and exit from the programming mode.