1.Locate theData Link Port. It is locatedunder dash drivers side. Be sure you knowwhich pinsare8 and4.

(Notice port iswider on top row)

2.Make sure there are metal contact pins in terminals 8 and 4. Connect 8 to 4 with a suitable
jumper wire (leave the jumper wire connected throughout the programming procedure). Make
sure you know which terminals are 8 and 4. The vehicle will respond by locking and unlocking the
doors to signify entering of programming mode.

3.Press and hold both the LOCK and UNLOCK buttons together on the first transmitter to be
programmed. After about 15 seconds, the vehicle will respond by locking and unlocking the doors.
Release the buttons on the transmitter.

4.Within one minute, repeat the previous step on the remaining transmitters to be programmed.

5.Remove jumper wire applied to theOBDIIPort.