1.Turnthe ignition switch to the ON then OFF position.

2.Removethe RADIO fuse.

3.Cycle the ignition switchfrom the OFFposition to the RUNposition (as far as you can go
withoutcranking the engine)3 times within 5 second ending in the RUN position. The
vehicle will verifyentry into the programming mode by locking then unlocking the
door locks.

4.Press and hold both the LOCK and UNLOCK buttons on the first transmitter for
approximately15 seconds. The vehicle will verify programming by locking then
unlocking the door locks. Your new remote has been accepted and all existing
remote codes havebeen erased.

5.Repeat the previous step for each additional transmitter (including any existing
transmitters).You may program up to 4 transmitters.This must be done before the
RADIO fuse is reinstalled.

6.Place the ignition switch in the OFF position.IMPORTANT: The remote keyless entry
systemwill not be operational if the radio fuse is open.

7.Replace the RADIO fuse.If at any time it is necessary to restart the procedure, turn the
ignitionOFF and proceed again with step number 1.