IMPORTANT: Before entering programming mode, have in possession all of the transmitters you will be using on the vehicle. Once you program the transmitter, all previous codes will be erased from the memory. The other transmitters will not be functional until you program thetransmitters again.

1.Insert keys in ignition and leave in theOFF position.

2.Locate theDataPort which is located drivers side under dash about knee level.

3.Make sure there are metal contact pins in terminals 8 and4. Connect 8 and 4 with asuitable jumperwire(leave the jumper wires connected throughout the programming procedure).Make sure you know whichterminals are 8 and 4. The vehicle will respond by locking then unlocking the doors to signifyentering of theprogramming mode.

4.Press and hold both the LOCK and UNLOCK buttons together on the first transmitter to beprogrammed.Upto about 30 seconds, the vehicle will respond by locking then unlocking the doors. Releasethe buttons on the transmitter.

5.Within one minute, repeat the previous step on the remaining transmitter (if any – includingyour old one).

6.Remove jumper wire applied to the Data Port(disconnect 8 and 4).